
   ETC M321 - Dual Channel Arbitrary Waveform Generator  



RECOMMENDATIONS FOR THE GENERATOR USE

- read the README.TXT file before working with the device
- before adjusting or installing the add-on card turn your
  computer off
- secure the front panel with the screw before turning your
  computer on
- when setting the Base address, always install only one jumper
- do not connect voltage sources to the device outputs
- make sure that voltage connected to the trigger input does
  not exceed the range 0V to +5V
- Before using the generator please install the UNIEXD driver



Instalation of M321 SW
- start the SETUP.exe file and follow the installer instructions
